Silvia PID Installation Guide Part A Version 2.04
Copyright © 2006, 2008 MLG Properties, LLC
Page A-6
Locate and loosen (do not remove) the single screw at the very back of the U-shaped
enclosure panel that fastens the panel to the black metal base.
After you have loosened this screw, carefully work the back panel free. You will
probably have to spread the “U” just a little to allow it to clear the splash guard. Do not
be too aggressive in spreading the “U” as it is quite easy to put a kink in this panel down
at the bottom where there is a small notch in the turned lip.
Step A8 – Remove internal splash guard
Locate the two (2) screws holding the splash guard in place and remove them completely,
setting them safely in your Jello cup. Remove the splash guard and set it aside.
To Next Page
Loading...
