Silvia PID Installation Guide Part A Version 2.04
Copyright © 2006, 2008 MLG Properties, LLC
Page A-19
Note: Some users have suggested a simpler way to install the splitters:
1. Remove the original wire connections from the tabs (as directed above).
2. Install the splitters into the now-open female connectors on the ends of the
original wires
3. Install the splitter/wire combinations back onto the switch
4. Install the new wires on the open tabs of the splitters.
Step A14 – Install power supply wires for digital
controller
Locate a pair of black 20 gauge wires (be sure and read the note at the end of this step if
you have one black wire and one gray wire instead). These wires will have a red
insulated push-on connector on one end, and a short section of bare, stripped wire on the
other end.
To Next Page
Loading...
