Silvia PID Installation Guide Part B Version 96-2.04
Copyright © 2006, 2008 MLG Properties, LLC
Page B-2
Make sure you have the bottom cover oriented correctly – the countersunk holes should
be on the bottom, or outside. Pass the wires from the side with the countersunk holes to
the side without the countersunk holes.
Step B3 – Route wires through locking collar
Next, slide the locking collar off the back of your digital controller, and place the locking
collar inside the enclosure. Be sure that the orientation of the controller is correct with
respect how it will “grab” the controller Route all of your wires, except the green ground
wire, through the collar and out the front of the enclosure as shown below (the collar on
your controller may look a little different, depending on the model).
Step B4 – Fasten the ground wire
Fasten the green ground wire to the tab at the back of the enclosure, using the screw and
lock washer provided (left side mount shown – for right side mount the tab is on the
bottom).
To Next Page
Loading...
