R&S ESR7 - 11.16 Status Register; 11.16.1 General Status Register Commands

Remote Control
R&S
®
ESR
994User Manual 1175.7068.02 ─ 12
ENHanced
If subsequent commands are not found on the same tree level
as the previous command, the SCPI parser searches "back-
wards up the tree" of defined SCPI commands. If the command
is found at a higher node, that command is used. Only if the
command is not found anywhere, an error message is returned.
*RST: setting is retained
Example:
*RST
:SYSTem:TWALKing ENHanced
:SENSe:SWEep:MODE LIST
INIT:CONT OFF
LIST:RANG4:DEL;RANG3:DEL
//without enhanced tree walking this command would deliver an
error
Manual operation: See "Tree Walking" on page 517
11.16 Status Register
For more information on the contents of the status registers see the following sections.
Status registers in receiver mode:
●
"STATus:OPERation Register" on page 580
●
"STATus:QUEStionable Register" on page 581
●
"STATus:QUEStionable:FREQuency Register" on page 582
●
"STATus:QUEStionable:LIMit Register" on page 582
●
"STATus:QUEStionable:LMARgin Register" on page 583
●
"STATus:QUEStionable:POWer Register" on page 584
●
"STATus:QUEStionable:TRANsducer Register" on page 584
Status registers in spectrum mode:
●
"STATus:OPERation Register" on page 586
●
"STATus:QUEStionable Register" on page 587
●
"STATus:QUEStionable:ACPLimit Register" on page 588
●
"STATus:QUEStionable:FREQuency Register" on page 582
●
"STATus:QUEStionable:LIMit Register" on page 582
●
"STATus:QUEStionable:LMARgin Register" on page 583
●
"STATus:QUEStionable:POWer Register" on page 584
11.16.1 General Status Register Commands
STATus:PRESet.............................................................................................................995
STATus:QUEue[:NEXT?]?...............................................................................................995
Status Register