Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
766User Manual 1178.8520.02 ─ 01
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Manual operation: See " Limit Check " on page 165
See " Limit Checking " on page 172
See " Limit Checking " on page 177
See " Limit Checking " on page 180
14.5.3.6 General ACLR Measurement Settings
The following commands control the measurement algorithm.
Useful commands for the ACLR measurement described elsewhere:
●
[SENSe:]POWer:NCORrection on page 900
●
[SENSe:]POWer:ACHannel:PRESet on page 751
●
[SENSe:]POWer:ACHannel:PRESet:RLEVel on page 751
●
[SENSe:]POWer:TRACe on page 751
●
CALCulate<n>:MARKer<m>:FUNCtion:POWer<sb>:MODE on page 748
Remote commands exclusive to ACLR measurement
[SENSe:]POWer:HSPeed............................................................................................... 766
[SENSe:]POWer:HSPeed <State>
This command turns high speed ACLR and channel power measurements on and off.
If on, the R&S FSV/A performs a measurement on each channel in the time domain. It
returns to the frequency domain when the measurement is done.
In some telecommunications standards, high speed measurements use weighting fil-
ters with characteristic or steep-edged channel filters for band limitation.
Parameters:
<State> ON | OFF | 1 | 0
*RST: 0
Example:
POW:HSP ON
Manual operation: See " Fast ACLR " on page 162
14.5.3.7 Configuring MSR ACLR Measurements
If the "Multi-Standard Radio" standard is selected (see CALCulate<n>:MARKer<m>:
FUNCtion:POWer<sb>:PRESet on page 752), the channels for the ACLR measure-
ment are configured differently. (For more information see Chapter 7.3.3.4, "Measure-
ment on Multi-Standard Radio (MSR) Signals", on page 153.)
In this case, use the following commands.
Configuring and Performing Measurements
To Next Page
Loading...
