M3SR Series 4100 Selecting the Scan Groups
4.16 Operating Manual 6175.4760.02 – 01
4.3.5.1 Selecting the Scan Groups
Softkey Type Description
Listbox
In the central area the currently active value is
displayed.
1. Press 'SCAN GRP' softkey.
2. Select desired group from listbox.
3. Press 'ENT' to confirm. The new scan
group is now effective.
The scanning and next call scan groups are
used in combination with scan rate 2chPs or
5chPs (see
sect. 4.3.5.9 Selecting the Scan Rate).
The scan group is a number of channels
grouped together to be scanned and used for
calling.
The currently selected scanning scan group is
the one in which the radio is presently scan-
ning and listening for incoming ALE-2G calls.
The next call scan group is associated to the
currently selected destination address and is
used for calling the currently selected destina-
tion. If as next call scan group "rx = tx" is se-
lected, the next call scan group is the same as
the currently selected scanning scan group.
As each address has its own associated
scan group, changing the destination ad-
dress may also change the next call scan
group.
To Next Page
Loading...