Preparing for Use
R&S
®
RTM2000
13Getting Started 1317.4710.02 ─ 05
●
USB connectors, see also chapter 3.1.9, "Front Connectors", on page 23
●
Monitor connector, see also chapter 3.2, "Rear Panel", on page 23
Connecting USB devices
The USB interfaces on the front and rear panels of the R&S RTM allow you to connect
USB flash drives for easy transfer of data to and from a computer (e.g. firmware
updates), a printer to print measurement results, or a computer for remote control of
the instrument.
All USB devices can be connected to or disconnected from the instrument during oper-
ation. The instrument detects the USB device as soon as it is connected.
Connecting an external monitor
You can connect an external monitor to the DVI-D connector on the instrument's rear
panel. You can connect also a VGA monitor using an appropriate adapter.
Connecting a monitor
Before connecting a monitor, make sure that the instrument is switched off. Otherwise,
correct operation cannot be assured.
Connecting External Devices
To Next Page
Loading...
