Need help?Do you have a question about the R&S ZC Series and is the answer not in the manual?
General| Brand | R&S |
|---|---|
| Model | ZC Series |
| Category | Media Converter |
| Language | English |
Information on labels on the casing regarding product and environment safety.
Explains warning messages and their meaning to indicate risks.
Steps for unpacking the converter and checking its completeness.
Guidance on selecting suitable operating conditions to avoid product damage.
Information on mounting and adjusting the converter for operation.
Advice on cable selection and mitigating electromagnetic interference.
Procedure for connecting the converter to the specified DC power supply.
Prerequisites and steps for safely switching on the converter.
Steps to connect the converter to the VNA using a USB cable for data transfer.
Overview of the test port adapter and its specifications for connecting DUTs.
Details on the knurled knob for adjusting the output power via a variable attenuator.
Description of connectors and control elements located on the rear panel.
Information on the power supply connector and the meaning of status LED colors.
Details on the 2.92 mm female input connectors for LO IN and RF IN signals.
Details on the SMA female output connectors for MEAS OUT and REF OUT signals.
Information on the USB Type B connector for VNA control.
Description of the connector for controlling the electronic attenuator on the ZC90E.
Step-by-step guide for connecting the frequency converters to the R&S ZNA.
Instructions for connecting the RF IN and LO IN ports to the R&S ZNA.
Instructions for connecting the MEAS OUT and REF OUT ports to the R&S ZNA.
Details on R&S ZCAKN adaptation kits for connecting R&S ZNA accessories.
Lists the necessary equipment and hardware options for standard setups.
Outlines the sequence of steps for configuring and performing measurements.
Guide on using the R&S ZNA-K8 software option for converter configuration.
Procedure for performing scalar power calibration and leveling.
Recommendation for system error correction using a calibration kit.
Instructions for performing measurements after setup and calibration.
Provides extra details, including warm-up time and pulsed signal considerations.
Instructions for cleaning the product safely and effectively.
Guidelines for disposing of electrical and electronic equipment.
Steps for connecting RF cables between converters and VNA.
Details on connecting input connectors using appropriate cables and adapters.
Instructions for connecting output connectors to the network analyzer.
Information on R&S ZCAK adaptation kits for different VNA models.
Lists the necessary equipment for measurements with frequency converters.
Outlines the fundamental steps involved in the measurement process.
Steps to activate the converter mode on the VNA via USB or System Configuration.
Refers to sections for connecting power supply, analyzer ports, and DUT.
Details on performing output power calibration and receiver power calibration.
How to perform mm-wave measurements and use the Converter Leveling Tool.
Provides additional details on operating manual and relevant textbooks.
To Next Page