R&S ZC Series - Index

Index
R&S
®
ZCxxx
48Getting Started 1177.5156.02 ─ 05
Index
A
Adjusting knob .........................................15
Attenuator control connector (R&S ZC90E
only) .........................................................18
B
Basic operation ..................................26, 42
C
Calibration ......................................... 34, 45
Casing
Labels ................................................... 5
Checking the delivery ................................ 9
Converter setup .................................10, 27
Customer support ....................................37
D
Disposal ...................................................36
F
Frequency converter mode ..................... 44
I
Input powers ............................................18
L
Labels on casing ....................................... 5
Leveling ................................................... 30
LO IN ....................................................... 18
M
Maintenance ............................................36
MEAS OUT ..............................................18
Measurement .................................... 34, 46
Measurement principle ...................... 27, 43
P
Power adjusting knob .............................. 15
Power calibration .....................................45
Power supply connector .......................... 17
Preparing for use .................................9, 13
R
R&S ZC90E
Attenuator control connector ...............18
Rear panel ...............................................16
REF OUT .................................................18
Required Equipment ..........................26, 42
RF connection ................................... 20, 38
RF connector inputs ................................ 18
RF connector outputs .............................. 18
RF IN ....................................................... 18
S
Safety instructions
Warning messages ............................... 6
Scalar power calibration .......................... 30
Standard setup ........................................ 20
System Configuration .............................. 45
System error correction ..................... 34, 46
T
Test port ...................................................13
Test port adapter ..................................... 13
U
Unpacking ................................................. 9
USB connector ........................................ 18
W
Warning messages ....................................6
Waveguide flange ....................................13