R&S ZC Series - Output Connectors (MEAS OUT, REF OUT); Adaption Kits R&S ZCAKN

RF connections
R&S
®
ZCxxx
24Getting Started 1177.5156.02 ─ 05
5.3 Output connectors (MEAS OUT, REF OUT)
For the R&S ZNA standard setup, proceed as follows:
1. Connect the MEAS OUT connectors of the converters to the IF Meas connec-
tors of the R&S ZNA.
2. Connect the REF OUT connectors of the converters to the IF Reference con-
nectors of the R&S ZNA.
Use the same VNA port number for the RF IN, MEAS OUT, and REF OUT
connection of a converter.
Suitable cables for connecting the output connectors to the network analyzer are
included in the converter shipment. The connectors of these cables are labeled
accordingly.
5.4 Adaption kits R&S ZCAKN
The standard setups shown in Figure 5-1 and Figure 5-2 use the following
Rohde & Schwarz network analyzer accessories:
●
Cables
– R&S ZV-Z195: Test port cable 0 Hz to 40 GHz, 2.92 mm (f) – 2.92 mm (m)
Adaption kits R&S ZCAKN