R&S ZNA26 - Page 1058

Command reference
R&S
®
ZNA
1058User Manual 1178.6462.02 ─ 20
Options: R&S ZNA-K2
Manual operation: See "Start Distance / Stop Distance" on page 763
CALCulate<Chn>:TRANsform:DTFault:STATe <DtfState>
If channel <Chn> is performing an unsegmented frequency sweep, this command
allows to transform its active trace into a Distance to Fault (DtF) trace.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<DtfState> OFF|ON – DtF disabled|enabled
*RST: OFF
Example:
:CALCulate1:TRANsform:DTFault:STATE ON
turns the DtF representation of the active trace of channel 1 ON.
Options: R&S ZNA-K2
Manual operation: See "Distance to Fault" on page 762
7.3.1.25 CALCulate:TRANsform:VNETworks...
The CALCulate:TRANsform:VNETworks... commands define and activate the cir-
cuit models for the different de-/embedding types. SeeChapter 4.6.2, "Embedding and
deembedding", on page 207 .
The circuit models are addressed by predefined enum constants. Except for the FIM-
Port model, that consists of a single snp file, the models and constants are different for
the different de-/embedding types.
Table 7-6: Circuit models for single ended port embedding/deembedding
Parameter Circuit model Pictogram
FIMPort File import, generic 2-port (no circuit model)
CSL Serial C, shunt L
LSC Serial L, shunt C
SCPI command reference