Command reference
R&S
®
ZNA
1218User Manual 1178.6462.02 ─ 20
GREen
Green color, permanently on
RED
Red color, permanently on
FGReen
Green color, flashing
FRED
Red color, flashing
OUTPut:UPORt:ECBits <Boolean>
Defines the usage of pins 16 to 19 of the USER PORT connector.
Parameters:
<Boolean> ON – channel bits 4 to 7
OFF – drive port 1 to 4
*RST: ON
Example: See OUTPut<Ch>:UPORt[:VALue]
Manual operation: See "Pin 16 - 19" on page 795
OUTPut<Ch>[:STATe] <Boolean>
Turns the internal source power at all ports and the power of all external generators on
or off.
Suffix:
<Ch>
.
Channel number. This suffix is ignored; the setting is valid for all
channels.
Parameters:
<Boolean> ON | OFF - switch the power on or off.
*RST: ON
Example:
OUTP OFF
Turn off the RF source power.
Manual operation: See "RF Off All Channels" on page 477
OUTPut[:STATe]:TYPE <OutputTypeMode_Descript>
Allows you to define how the R&S ZNA turns the RF power off.
Parameters:
<OutputTypeMode_Descript>FAST | LBNoise
FAST
Only the RF switch is used (default).
LBNoise
In addition to the switches, all amplifiers are turned off. Results
in lower broadband noise.
SCPI command reference
To Next Page
Loading...
