R&S ZNA26 - Page 1230

Command reference
R&S
®
ZNA
1230User Manual 1178.6462.02 ─ 20
[SENSe:]CDLL:REMove <DllName>
Tells the analyzer firmware to remove a custom (external) DLL that was previously
added using [SENSe:]CDLL:ADD.
Note that adding/removing custom DLLs is only possible if the firmware is run as
administrator.
Setting parameters:
<DllName> Name of a loaded DLL (see [SENSe:]CDLL:LIST?)
Lowercase string, without dll extension
Usage: Setting only
Manual operation: See "Add / Remove" on page 357
[SENSe:]CDLL:LIST:TASK? <DllName>
Lists the tasks implemented by the custom (external) DLL <DllName>.
Query parameters:
<DllName> Name of a loaded DLL (see [SENSe:]CDLL:LIST?)
Lowercase string, without dll extension
Usage: Query only
[SENSe<Ch>:]CDLL:PERManent:ADDitional <DllName>, <Additional Input>
[SENSe<Ch>:]CDLL:PERManent:ADDitional? <DllName>
Defines additional input for the task to be run, if custom DLL <DllName> is set to per-
manent mode in channel <Ch> ([SENSe<Ch>:]CDLL:PERManent[:STATe]
'<'DllName>', ON).
Use [SENSe<Ch>:]CDLL:PERManent:TASK to select the type of task to be run.
Suffix:
<Ch>
.
Channel number
Parameters:
<Additional Input> String value, with DLL-specific syntax and semantics. See the
docs of your DLL for details.
Parameters for setting and query:
<DllName> Name of a loaded DLL (see [SENSe:]CDLL:LIST?)
Lowercase string, without dll extension
Manual operation: See "Additional Input" on page 357
SCPI command reference