Command reference
R&S
®
ZNA
1289User Manual 1178.6462.02 ─ 20
Example:
CORR:COLL:AUTO:TYPE FNPort, '', 1, 2, 4
Perform an automatic full 3-port calibration at test ports 1, 2,
and 4 using the calibration unit's default calibration kit file and
arbitrary test ports of the cal unit.
Usage: Setting only
Manual operation: See "Apply" on page 526
[SENSe<Ch>:]CORRection:COLLect:AUTO:UTHRough <TestPort1>, <TestPort2>
With this command, you can perform the Unknown Through measurement during an
automatic UOSM calibration.
Although it works for all calibration units, it is only useful if the calibration unit selected
using SYSTem:COMMunicate:RDEVice:AKAL:ADDRess is an inline calibration sys-
tem (ICS).
Suffix:
<Ch>
.
Channel number
Setting parameters:
<TestPort1>,
<TestPort2>
VNA test port numbers
Example: See Chapter 8.2.5.5, "Inline calibration", on page 1622.
Usage: Setting only
[SENSe<Ch>:]CORRection:COLLect:CKIT:INSTall <CalKitFile>, <Gender>[,
<Ports>]
Allows you to load cal kit data by gender:
●
From the given file
●
To the given ports or all ports
Use MMEMory:CKIT:INFO? on page 1181 to get information about cal kit files.
Suffix:
<Ch>
.
Channel number
Setting parameters:
<CalKitFile> Path to the cal kit file, either absolute or relative to the current
directory (see MMEMory:CDIRectory)
<Gender> MALE | FEMale | NGENder
<Ports> Either a comma-separated list of port numbers or ALL (optional)
Usage: Setting only
SCPI command reference
To Next Page
Loading...
