Command reference
R&S
®
ZNA
1470User Manual 1178.6462.02 ─ 20
Example:
SYST:COMM:RDEV:GEN1:DEF 'Ext. Gen. 1', 'SME02',
'gpib0', '21'
Configure an R&S SME02 generator as external generator no.
1, assigning the name Ext. Gen. 1 and a GPIB address 21.
SOUR:POW:GEN:PERM ON
Activate the generator as an external signal source.
Manual operation: See "Source Gen" on page 615
SOURce<Ch>:POWer<PhyPt>:GENerator<Gen>:STATe <Boolean>
Turns an external generator numbered <Gen> on or off.
Suffix:
<Ch>
.
Channel number
<PhyPt> Test port number of the analyzer. This suffix is ignored; the gen-
erator is selected via <Gen>.
<Gen> Generator number
Parameters:
<Boolean> ON | OFF - generator is on or off
*RST: ON
Example:
SYST:COMM:RDEV:GEN1:DEF 'Ext. Gen. 1', 'SME02',
'gpib0', '21'
Configure an R&S SME02 generator as external generator no.
1, assigning the name "Ext. Gen. 1" and a GPIB address 21.
SOUR:POW:GEN:STAT OFF
Turn the external generator off. In the "Port Configuration" dia-
log, "RF Off" is checked for generator no. 1.
Manual operation: See "Source RF Off" on page 615
SOURce<Ch>:POWer<PhyPt>:GENerator<Gen>:LLIMit[:STATe] <arg0>
Enables or disables the limit for the source power of an external generator no. <Gen>.
The limit is defined using
SOURce<Ch>:POWer<PhyPt>:GENerator<Gen>:LLIMit:VALue.
Suffix:
<Ch>
.
Channel number. This suffix is ignored; the setting applies to all
channels.
<PhyPt> Test port number of the analyzer. This suffix is ignored; the gen-
erator is selected via <Gen>.
<Gen> Generator number
Parameters:
<arg0> ON | OFF: Enable or disable the power limit.
*RST: The power limit settings are not changed after a
*RST. The factory setting is OFF.
SCPI command reference
To Next Page
Loading...
