GUI reference
R&S
®
ZNA
301User Manual 1178.6462.02 ─ 20
Depending on the desired DUT and measurement, the measurement channel has to
be prepared in a particular way. A dedicated multi-channel setup dialog guides you
through the channel configuration (see Chapter 4.2.2.3, "Multi-channel setup dialog",
on page 112).
S-Params (Non-Frequency Converting DUTs)
The "Meas" softtool for non-frequency converting DUTs provides the following tabs:
Table 5-2: Meas softtool for S-Params Measurements
"Meas" softtool tab Channel Mode Required Software Option
S-Params tab S-Params -
Wave tab
Ratio tab S-Params The "Harmonics" part requires
R&S ZNA-K4
Noise Figure tab Noise Figure R&S ZNA-K30
Intermodulation tab Intermodulation R&S ZNA-K4
Gain Compression tab Amplifier Compression -
Time Domain tab - R&S ZNA-K2
Time Gate tab
Meas softtool
To Next Page
Loading...
