GUI reference
R&S
®
ZNA
324User Manual 1178.6462.02 ─ 20
CALCulate<Ch>:PARameter:MEASure <TraceName>, 'NF1R' | 'NF2R'
| ...
CALCulate<Ch>:PARameter:SDEFine <TraceName>, 'NF1R' | 'NF2R'
| ...
5.2.5.2 Noise figure setup dialog
The NF "Setup" dialog is an instance of the Multi-channel setup dialog. It allows you to
set up a noise figure (NF) measurement.
Access: Noise Figure tab ("S-Params") > "Noise Figure" tool button
The noise figure specific parameters in the lower part of the dialog are identical for
non-frequency-converting and frequency-converting measurements.
Figure 5-2: NF Setup dialog: non-frequency-converting
The frequency conversion settings in the frequency-converting variant of the dialog are
identical to the settings in the Scalar Mixer Meas setup dialog.
Meas softtool
To Next Page
Loading...
