GUI reference
R&S
®
ZNA
521User Manual 1178.6462.02 ─ 20
Start Cal Sweep
The dock widget below the diagrams shows the calibrated ports and standards and vis-
ualizes the measurement progress.
Use the buttons representing the calibration standards to start the corresponding cali-
bration sweeps.
If "Show Cal Kit Label" is enabled on the Calibration tab of the "System Config" dialog,
an additional "Calibration Info" dialog is displayed. In this case, the cal sweep is started
from this dialog.
For SMARTerCals, an additional receiver power calibration at one of the ports is
required:
Cal softtool
To Next Page
Loading...
