GUI reference
R&S
®
ZNA
659User Manual 1178.6462.02 ─ 20
This panel can also be activated by selecting the Ground Loop tab softtool tab. Refer
to its description for background information, parameters and additional remote com-
mands.
If multiple port groups (DUTs) are configured and Ground Loop per Port Group is
enabled, the panel displays the available port groups. Select the port group whose
ground loop network shall be configured.
Active
The checkboxes in the "Active" column activate or deactivate the configured ground
loop deembedding/embedding (i.e. adds or removes it to/from the calculation flow)
without changing its parameters.
Remote command:
CALCulate<Ch>:TRANsform:VNETworks:GLOop:DEEMbedding<group>[:
STATe]
CALCulate<Ch>:TRANsform:VNETworks:GLOop:EMBedding<group>[:STATe]
File Name 1
The ellipsis button in the "File Name 1" column is enabled if a 1-port data Network net-
work (*.s1p file) is selected.
Note: The loaded S-parameter trace is stored in the active recall set. Persisted recall
sets contain the full embedding and deembedding data so that they can be transferred
to other instruments.
Remote command:
MMEMory:LOAD:VNETworks<Ch>:GLOop:DEEMbedding<group>
MMEMory:LOAD:VNETworks<Ch>:GLOop:EMBedding<group>
5.14.1.7 Impedance Renormalization panel
This panel provides alternative access to the reference impedance settings (see "Ref-
erence Impedance tab" on page 313).
Offset Embed softtool
To Next Page
Loading...
