Instrument tour
R&S
®
ZNA
31Getting Started 1178.6456.02 ─ 18
4.2 Rear panel
This section gives an overview of the rear panel elements of the network analyzer.
1
2 3 4 5 6
7
8 9 10
11
12
13
14
15
17
18
19
21
22
16
Table 4-1: Rear panel elements available on all instruments
Index Label Description
1 System Drive Removable system drive of the R&S ZNA, containing all software (including the operating
system and the VNA application) and data. No other drive is built in. Do not remove the
system drive during operation.
Option R&S ZNA-B19 provides an additional removable system drive (including operating
system and firmware).
2 Display Port External monitor connector (DisplayPort); see Chapter 3.11.1, "Connecting a monitor",
on page 21.
3 DVI Digital only External monitor connector (DVI-D); see Chapter 3.11.1, "Connecting a monitor",
on page 21.
4 LAN RJ-45 connector to integrate the instrument to a Local Area Network, primarily for remote
control purposes; see Chapter 7.2.1, "Assigning an IP address", on page 72.
5 USB Type A USB host (master) connectors. Similar functionality as the USB connectors on the
front panel (see Chapter 4.1.4.3, "USB connectors", on page 30).
6 USB Device Type B USB device (slave) connector for remote control of the instrument (see Chap-
ter 3.11.6, "Connecting a USB cable for remote control", on page 23).
7 I/O Power on/off switch, see Chapter 3.7, "Switching the instrument on and off", on page 17
8 GPIB IEEE 488 GPIB bus connector according to standard IEEE 488 / IEC 625.
Rear panel
To Next Page
Loading...
