R&S ZNLE Series - Page 40

Instrument Tour
R&S
®
ZNLE
40Getting Started 1323.2873.02 ─ 07
Function key Assigned functions
[Display Lines] Configures display lines and limit lines.
[Cal]
[Single]
Provides all functions related to system error calibration.
[Channel]
[Cont]
Creates and deletes channel setups and optimize the measure-
ment process.
5.1.6 Keypad
The keypad is used to enter numeric parameters, including the corresponding
units. It contains the following keys:
Table 5-3: Keys on the keypad
Type of key Description
Decimal point Inserts a decimal point "." at the cursor position.
Sign key Changes the sign of a numeric parameter. In the case of an
alphanumeric parameter, inserts a "-" at the cursor position.
Unit keys
(G/n, M/μ, k/m, x1)
Adds the selected unit to the entered numeric value and com-
plete the entry.
In the case of level entries (e.g. in dB) or dimensionless values,
all units have the value "1" as multiplying factor. Thus, they have
the same function as an [ENTER] key.
[ESC] Closes all kinds of dialog boxes, if the edit mode is not active.
Quits the edit mode, if the edit mode is active. In dialog boxes
that contain a "Cancel" button it activates that button.
For "Edit" dialog boxes the following mechanism is used:
●
If data entry has been started, it retains the original value
and closes the dialog box.
●
If data entry has not been started or has been completed, it
closes the dialog box.
Front Panel View