R&S ZNLE Series - Page 44

Instrument Tour
R&S
®
ZNLE
44Getting Started 1323.2873.02 ─ 07
5 = "DVI" connector for external display
6 = "LAN" connector
7 = "USB" (3.0) connectors
5.2.1 AC Power Supply Connection and Main Power Switch
An AC power supply connector and main power switch are located in a unit on
the rear panel of the instrument.
Main power switch function:
Position 1: The instrument is in operation.
Position O: The entire instrument is disconnected from the AC power supply.
For details, refer to Chapter 4.1.4, "Connecting the AC Power", on page 16.
5.2.2 GPIB Interface
The optional GPIB interface (R&S FPL1-B10) is in compliance with IEEE488 and
SCPI. A computer for remote control can be connected via this interface. To set
up the connection, a shielded cable is recommended.
5.2.3 Ref. In / Ref. Out
The Ref. In connectors are used to provide an external reference signal to the
R&S ZNLE.
The Ref. Out connectors can be used to provide a reference signal from the
R&S ZNLE to other devices that are connected to this instrument.
Various connectors are provided for different reference signals:
Connector Reference signal Usage
Ref. In 10 MHz
10 dBm
To provide an external reference signal on the
R&S ZNLE.
Ref. Out 10 MHz
10 dBm
To provide the internal reference signal from the
R&S ZNLE to another device continuously.
Rear Panel View