R&S ZNLE Series - Page 48

Trying Out the Instrument
R&S
®
ZNLE
48Getting Started 1323.2873.02 ─ 07
1. Connect the DUT between test ports 1 and 2 of the network analyzer as
shown above.
2. Switch on the instrument and start the VNA application.
Proceed as described in Chapter 4.1.5, "Switching the Instrument On and
Off", on page 16.
3. Use the [Preset] key to restore a well-defined instrument state.
The analyzer is now set to its default state. The default measured quantity is
the transmission S-parameter S
21
.
Select [Trace] and use the control elements in the "Traces" softtool tab if
you wish to create additional traces and diagrams.
6.1.1.2 Selecting the Sweep Range and Other Parameters
After a system preset the display shows a diagram with a dB magnitude scale,
and the S-parameter S
21
is selected as a measured quantity. This S-parameter is
Performing Measurements