R&S ZNLE Series - Page 55

Trying Out the Instrument
R&S
®
ZNLE
55Getting Started 1323.2873.02 ─ 07
You can also use the basic transmission test setup, e.g. if you want to mea-
sure reflection and transmission parameters in parallel.
●
The analyzer provides special calibration types for reflection measurements.
Use the calibration wizard and select an appropriate type.
The full 2-port calibration TOSM corrects the system errors for all transmission
and reflection S-parameters.
●
Some of the trace formats are particularly suited for reflection measurements.
For instance, you can display the measured reflection coefficient S
11
in a
Smith chart to obtain the complex input impedance at port 1.
Performing Measurements