6
PROPER LIGHTING LOCATION AND WARNINGS
As with any gas appliance, care should be given when lighting your Burner.
Never use a standard kitchen match or cigarette light to light the burner. Al-
ways use a long stem lighter or a long fire place match, this will allow you to
keep your hands completely clear of the mixing chamber.
Always use caution when lighting burner. Crack open the needle valve and ig-
nite at the top of the burner/jet tube with a long stem trigger propane lighter. Do
not allow the gas to build up. If smoker does not ignite within in 3 seconds,
close needle valve and wait 1 minute before attempting to light the burner. Nev-
er place your any part of your body in over the top of the burner or burner
frame.
ALWAYS USE A LONG STEM LIGHTER
WHEN LIGHTING Burner!
NEVER USE A CIGARETTE LIGHTER
OR A KITCHEN MATCH!
15
4 ea. 1/4” Nuts
To Remove Basket
This pertains to both the CSB30 and CSB60 Boiler
To install the Basket Support, Place the Support behind the
cooker and aligned with the bolting flange. Attach using 5/16” X
3/4” (2 ea.) and 5/16” Nuts (2 ea.). Repeat process on the other
side. Adjust the Lid Supports so that the lid completely on the lid
support. Tighten the fasteners securely.
To remove Basket from Cooker. Remove 2 ea. 1/4 x 3/4 Bolts from
the Basket Retainer Plate. Repeat this for other side. Rotate
basket up and pull basket towards the front of the cooker. Lift
basket free of boiler.
Shute Extension
Shute Rail inside
of Boiler Lid
To Install Extensions
This pertains to the CSB60 only.
The Shute extensions are designed to prevent losing crawfish/
seafood down the outer edges of the CSB60 when dumping into a
smaller ice chest. To install the shute extensions on the
Csb60 place the extension against the shute rail welded inside
the CSB60’s lid. The hook of the extension will need to face down
and to the outer edge of the lid. Slide the extension out until the
hook clears the outer edge of the lid and then slide the extension
down to allow the hook to catch under the lid. Repeat this
process to install the extension on the other side.
4 ea. 1/4” x
3/4” Bolts
4 ea. 5/16” x
3/4” Bolts
4 ea. 5/16”
Nuts
To Next Page
Loading...