Rangemaster SxS 663 - Appliance Levelling and Handle Fitting

16
Levelling the Fridge-freezer and
Adjusting the Doors
Make sure that the appliance is on solid level ooring. If the
refrigerator is placed on a plinth, at, strong and re resistant
materials must be used.
This appliance has front adjustable feet, which can be used to
level the appliance.
Insert a suitable at screwdriver into the slots of the
adjustable feet. Turn the screwdriver clockwise to raise the
feet, and counter-clockwise to lower the feet (Fig.4-9).
Levelling the Doors
The doors may require some alignment before connecting
the fridge-freezer to the electrical supply. This can be done by
adjusting the levelling feet (Fig.4-9).
To raise the left-hand door turn the left-hand foot clockwise
until it is level.
To raise the right-hand door, turn the right-hand foot
clockwise until it is level (Fig.4-10).
Fitting the Handles
The door handles x onto the mounting studs already tted
to each door (Fig.4-11).
Use the M3 grub screws and Allen key from the instruction kit
bag. Each handle will require 3 grub screws.
1. Place the handle rmly over the mounting studs.
2. Insert the grub screw into the hole located under each
handle stando bar.
3. Using the M3 Allen key, tighten the grub screw xing
the handle to the door.

Do not over-tighten the grub screw.
ArtNo.600-0035 - Adjusting the feet
Fig.4-10
Fig.4-9
Handle
Standoff bar
Grub screw
Fig.4-11