11
Cancelling a Programme
Follow the steps below to cancel a programme while in
operation.
1. Open the door of the machine, the selected programme
will be shown on the display.
2. Press and hold the Programme selection button (2) for
3 seconds. At the end of 3 seconds, ‘1’ will show on the
Display (3).
3. The water discharge process will start after the door of
the machine is closed and will continue for 30 seconds.
When the programme is cancelled, a buzzer will sound
5 times.
Switching the Machine Off
“00” will be shown on the display when the selected wash
programme is complete, a buzzer will also sound 5 times. You
can then switch your machine o using the Power On/O
button (1).
NOTE: Do not open the door before a programme is
complete.
NOTE: If the door of the machine is opened or the power is
cut during operation, the programme will continue when the
door is closed or the power returns.
NOTE: If the power is cut or the machine door is opened
during the drying process, the programme will terminate.
Your machine will now be ready for a new programme
selection.
Buzzer Sound Control
To change the buzzer sound level, follow the below steps:
1. Open the door and press the Programme (2) and Delay
(4) buttons simultaneously for 3 seconds.
2. When the sound setting is recognised, the buzzer gives
a long sound and the machine will display the last set
level, from “S0” to “S3”.
3. To decrease the sound level press the Programme
button (2). To increase the sound level, press the Delay
button (4).
4. To save the selected sound level, turn o the machine.
’’S0’’ level means all voices are o. Factory setting is “S3”.
Power Save Mode
To activate or deactivate power save mode, follow the below
steps:
1. Open the door and press the Delay (4) and Half Load (5)
buttons simultaneously for 3 seconds.
2. After 3 seconds, the machine will display last Setting,
“IL1” or “IL0”.
3. When Power Save Mode is activated, “IL1” will be
displayed. On this mode, interior lights will turn o 4
minutes after the door is opened, and the machine will
turn o after 15 minutes of no activity in order to save
energy.
4. When Power Save Mode is deactivated “IL0” will be
displayed. If Power Save Mode is deactive, interior lights
will be on as long as the door is open, and the machine
will always be on unless it is turned o by user.
5. To save the selected setting, turn o the machine.
In factory setting, Power Save Mode is active.
Info. LED (Model Dependent)
LED Indicator State of the Machine
Red, continuous
The machine is running a
program.
Red, ashing A program is cancelled.
Red, ashing rapidly
The machine has a fault. Refer
to section “Automatic fault
warnings and what to do”.
Green, continuous Program has nished.
To Next Page
Loading...
