Rangemaster T60 - Before Using Your Appliance; First Time Setup; Filling the Salt Compartment; Water Hardness and Softening

4
Preparing your Dishwasher for first use
• Make sure the electricity and supply water specifications
match the values indicated in the installation
instructions for the machine.
• Remove all packaging material inside the machine.
• Set the water softener level.
• Fill the rinse aid compartment.
Fill the salt (IF AVAILABLE)
To add softener salt, open the salt compartment cap by
turning it counter clockwise. (1) (2) At rst use, ll the
compartment with 1 kg salt and water (3) until it is almost
overowing. If available, using a funnel (4) will make lling
easier. Replace the cap and close it. After every 20-30 Cycles
add salt into your machine until it lls up (approx. 1 kg).
Only add water to the salt compartment on first use.
Use softener salt specically produced for use in dishwashers.
When you start your dishwasher, the salt compartment is
lled with water, therefore put the softener salt in prior to
starting your machine.
If the softener salt has overowed and you do not start
the machine immediately, run a short washing program to
protect your machine against corrosion.
2. Before Using Your Appliance
Test Strip
Run water
through
the tap
(1min.)
Keep the
strip in the
water (1sec)
Shake the
strip.
Wait
(1min.)
Set the
hardness
level
of your
machine.
1
2
3
4
5
6
NOTE: The level is set to 3 as default. If the water is well water
or has a hardness level above 90 dF, we recommend that you
use lter and renement devices.
Water Hardness Table
Level
German
dH
French
dF
British
dE
Indicator
1 0-5 0-9 0-6 L1 is shown on the display.
2 6-11 10-20 7-14 L2 is shown on the display.
3 12-17 21-30 15-21 L3 is shown on the display.
4 18-22 31-40 22-28 L4 is shown on the display.
5 23-31 41-55 29-39 L5 is shown on the display.
6 32-50 56-90 40-63 L6 is shown on the display.
Water Softener System
The dishwasher is equipped with a water softener which
reduces the hardness in the mains water supply. To nd out
the hardness level of your tap water, contact your water
company or use a test strip (if available).
Setting
Push the programme button and hold it down.
Turn on the machine.
Hold down the programme button until “SL” disappears.
The machine will display the last setting.
Set the level by pushing the programme button.
Switch o the machine to save the setting.
3 4
1 2
SALT