Rangemaster T60 - Installation; Positioning and Water Connection

12
c
a
b
5. Looking after your Dishwasher
Fig. 5.1
Fig. 5.2
Fig. 5.3
Fig. 5.4
Cleaning your dishwasher is important to maintain the
machine’s service life Make sure that the water softening
setting (If available) is done correctly and correct amount of
detergent is used to prevent limescale accumulation. Rell
the salt compartment when the salt sensor light comes on.
Oil and lime may build up in your Dishwasher over time. If this
occurs:
• Fill the detergent compartment but do not load
any dishes. Select a programme which runs at high
temperature and run the Dishwasher empty. If this does
not clean your Dishwasher sufficiently, use a cleaning
agent designed for use with dishwashers.
• To extend the life of your dishwasher, clean the
appliance regularly; once a month.
• Wipe the door seals regularly with a damp cloth to
remove any accumulated residue.
Filters
Clean the lters and spray arms at least once a week. If any
food waste remains on the coarse and ne lters, remove
them and clean them thoroughly with water.
a. Micro Filter
b. Coarse Filter
c. Metal Filter
• To remove and clean the Micro/Coarse filter
combination, turn it counter clockwise and take it out
by lifting upwards (Fig. 5.1 and Fig. 5.2).
• Pull and remove the metal filter (Fig. 5.3).
• Rinse the filters with lots of water until they are free of
residue.
• Refit the metal filter.
• Insert the Micro/Coarse filter and rotate it clockwise
(Fig. 5.4).