Rangemaster T60 - Technical Data; Dimensions & Connections; Appliance Technical Specifications

15
Automatic fault warnings and what to do
ERROR CODE POSSIBLE FAULT WHAT TO DO
FF Water inlet system failure
Make sure the water inlet tap is open and water is owing.
Separate the inlet hose from the tap and clean the lter of
the hose.
Contact for service if the error continues.
F5 Pressure system failure Contact for service.
F3 Continuous water input Close the tap and contact for service.
F2 Inability to discharge water
Water discharge hose and lters may be clogged.
Cancel the program.
If the error continues, contact for service.
F8 Heater error Contact for service.
F1 Overow
Unplug the machine and close the tap.
Contact for service.
FE Faulty electronic card Contact for service.
F7 Overheating error Contact for service.
F6 Faulty heater sensor Contact for service.
F9 Divisor position error Contact for service.
HI High voltage failure Contact for service.
LO Low voltage failure Contact for service.
The installation and repair procedures should always be carried out by the Authorised Service Agent, in order to avoid possible
risks. The manufacturer shall not be held liable for damages that may arise from procedures carried out by unauthorised
persons. Repairs may be carried out by technicians only. If a component has to be replaced, ensure that only original spare
parts are used.
Improper repairs or use of non-original spare parts may cause considerable damage and put the user at considerable risk.
Contact information for your customer service can be found on the back of this document.
Function-relevant genuine spare parts according to the corresponding Ecodesign order can be obtained from Customer
Service for a period of at least 10 years from the date on which your appliance was placed on the market within the European
Economic Area.