R76 Series of Tire Changers 11 P/N 5900346 — Rev. C — Dec. 2019
Installation Checklist
Following are the steps needed to install the Tire Changer. Perform them in the order shown.
☐ 1. Review the installation Safety Rules.
☐ 2. Make sure you have the necessary Tools.
☐ 3. Find an appropriate Location.
☐ 4. Make sure there is adequate Clearance around and above.
☐ 5. Unpack the Tire Changer.
☐ 6. Anchor the Tire Changer.
☐ 7. Connect to Power.
Requires a licensed Electrician
.
☐ 8. Connect to Air.
☐ 9. Prepare the Lube Bucket.
☐ 10. Grease the Assist Tower Post (R76ATR only).
☐ 11. Test the Tire Changer.
☐ 12. Review the Final Checklist.
To Next Page
Loading...
