12
Rascal P327 Mini / P327 Mini SL Powerchair Owner’s Manual & Service Record
Note: If you do remove the armrest completely,
make sure that the seat-belt (if fitted to your model)
is correctly installed on re-fitting of the armrest.
Armrest Height Adjustment
Loosen height adjustment knobs (One on each
armrest Fig.7), and raise or lower armrest so that it
is at a comfortable height. It may be better to have
someone else adjusting the armrest height while you
are sitting in the chair and making sure the armrests
are in a comfortable position before they are locked
in place. Finally tighten the knobs and ensure that
the armrests are secure.
Armrest Angle Adjustment
The armrest angle can be adjusted by flipping up
the armrest, and loosening the nut near the pivot
point (Fig.8). Then, using an Allen key turn the arm-
rest adjustment screw clockwise to lower the end of
the armrest or anticlockwise to raise it. Once satis-
fied, tighten the nut and lower the armrest.
Joystick Controller
Adjustment
The joystick controller position can be adjusted by
moving the joystick gently to the side and back. In
addition the joystick controller can be moved
forward and back by loosening the grub screw with
the Allen key provided (Fig.9), and setting to your
preferred position. Always ensure the grub screw
is secure and tight before using your Powerchair.
Ask your dealer if you wish to have the joystick on
the left hand armrest and they will make this change
for you.
7
Warning! NEVER drive with the armrest up
or with the armrest knob loose.
Warning! Do not use the armrest as a
support when getting in and out of your
Powerchair – Armrests are not designed to
fully support your weight.
Warning! Always check that the knobs are
tight and the armrests are secure before driving
the Powerchair.
8
9
To Next Page
Loading...
