Seat Back Folding and
Adjustment
The Seat Back can be folded down for transporting.
The seat back angle can be adjusted for comfort-
able sitting (Fig.10). The maximum reclining angle
is only for use when the chair is stationary, on a flat
surface with the power off. Note: If your Powerchair
is equipped with an optional attendant control
system or other rear of seat mounted accessory, it
may not be possible to recline beyond 105 degrees.
Headrest Adjustment
The headrest height can be adjusted by pressing in
the tab on the left hand collar and sliding the
headrest up or down (Fig.11). Make sure that the
collars have engaged into the headrest groves once
the adjustment has been made.
Swivel Seat (applies to
P327 Mini only)
This allows easy side access to the Powerchair
1. To operate, locate the release lever under the
seat (Fig.12).
2. Pull the lever up and the seat will release
allowing it to rotate.
3. Release the lever and the seat should lock
automatically, but always check it has.
Seat Height Adjustment
(applies to P327 Mini only)
You are advised to ask your dealer to set the seat
height in the most comfortable driving position.
13
10
11
12
Warning! Always return the seat to the
upright position before starting off. If the seat
back is tilted too far back, the risk of tipping
over backwards is increased, especially if
travelling up ramps, kerbs or hills.
Warning! Do not use this device if the vehicle
is on a slope. Always check the seat is locked
in the forward position before driving the vehicle.
To Next Page
Loading...
