Rascal R6 300 - Illustration 11 - Brake Release Lever

Rascal R6 300 Scooter Owner’s Manual
EMC Part: 19277200 • Rev. 06 • 09/04/2007
19
Illustration 11 — Brake Release Lever
When finished pushing the vehicle, place the lever back into the ‘DRIVE’ (down) position to prevent the
vehicle from rolling.
Note: The vehicle will not operate unless the Brake Lever is in the ‘DRIVE’ (lowered) position and the
Status Lamp will blink indicating that the Brake Lever is in the DRIVE Position.
WARNING!
Never sit in vehicle if it is in “freewheel” mode on an incline.
PUSH
POSITION
DRIVE
POSITION
19271200/12
WARNING!
Before sitting on the Scooter, make sure the Brake Lever is in DRIVE
(lower) position to prevent the vehicle from rolling. FAILURE TO DO SO
MAY RESULT IN INJURY.