Page 10 of 18
5. UVC LED Sterilizer (Default is always “ON”)
5.1 After the cold water temperature setting is completed, press to enter
UVC setting mode status. Press to “ON” UVC LED Sterilizer mode
and to “OFF”.
5.2 light will turn blue when the UVC LED Sterilizer is in use. Every 8
hours, the UVC LED Sterilizer will be activated for the first 4 hours. The
control logic might vary according to manufacturer product batches and
/ or versions.
6. Filter Lifespan Setting
6.1 After the UVC LED Sterilizer setting is completed, press to enter Filter
lifespan setting mode status. will start flashing to show the filter
lifespan, displaying pattern “00/01/02/03” on the right-hand side.
6.2 Filter life pattern comparison table
6.3 When the lifespan of filter is less than 200ml, dispensing button will
turn red. When filter lifespan is due, the buzzer will sound 3 times every
six hours until the lifespan is reset.
6.4 Press or to reset filter life to “00”.
To Next Page
Loading...