Page 7 of 18
cooling is finished.
* light will remain blue during dispensing of cold water. Press any Button to
stop dispensing.
4). - Volume selection Button (White light); used to select volume of water
dispensed from one of 3 values: 180ml, 220ml, or 1000ml.
* To avoid over dispensing, machine will automatically stop dispensing if more
than 1.5L of water has been dispensed continuously, or if it has been dispensing for
more than 2 minutes.
5). - Smart sensor: used to auto start and stop energy saving mode.
6). - Extra Hot Button (Red & White lights): Used to start and stop the extra hot
function. Button will turn red after being pressed until extra hot heating is
completed.
7). - Water Dispensing/Mixed Water/Setting Confirm Button (Red & White
lights): Press button after pressing or to dispense cold or hot water
respectively. Press the button alone will result in mixed water dispensing, which
dispenses some amount of cold water first and then mixes with hot water based on
the volume selected. (Indicated by the colour of the Waterspout, blue for cold
water and red for hot water)
When the life of the filter is about to expire, button will turn red and alert the
user to replace the filters.
8). - Setting/UVC LED Button (Blue and White lights); used to set time displayed
on , set temperature of hot and cold water, check filter lifespan, set flow
volume, turn energy saving mode off/on, and toggle the UVC LED sterilizer.
To Next Page
Loading...