P/N 016-0171-614 Rev. A 5
Installation & Configuration
2
Required Components
• 600S Antenna (one of the models listed below)
a. Base Model (063-2000-001)
b. GS Model (063-2000-002)
c. RTK Model (063-2000-003)
• Cable (one of the cables listed below)
a. Standard Cable (115-0172-246)
b. Phoenix 200 Adapter to 600S Cable (115-0172-303)
c. Case/Miller Adapter Cable (115-0172-285)
d. Case 30 Series Cable (115-0172-288)
System Power Requirements
In order for the 600S to perform properly they system must meet the following criteria:
• +8 to 36V DC
• 12V at the switched power is operational voltage for convergence. Lower voltages may work but
convergence times will be longer or may not converge.
• 2.9 Watts
Installation
1. Mount the GPS receiver on top of the vehicle cab with no overhead obstructions.
2. Follow the appropriate system drawing (below) for cable connections.
To Next Page
Loading...