What to do if Raven 600S Antenna receiver is in the error state and tracking is disabled?
If the Raven Antenna receiver is in an error state and tracking is disabled, it could be due to a fatal error or an unusual receiver status indicator set up to act like a fatal error. To resolve this, correct the cause of the error and then reset the receiver. The error status will persist until these steps are completed.
Guidance on following safety information and contacting Raven Industries for installation assistance.
Details the device's compliance with FCC Part 15 rules regarding interference.
Information on obtaining the latest manuals and software updates for Raven products.
Overview of the manual's purpose: providing instructions for 600S™ Antenna installation and configuration.
Details the key features and capabilities of the 600S Antenna, including supported technologies.
Guidance on acquiring satellite unlocks and authorization codes for enhanced functionality.
Presents receiver accuracy performance data for Absolute and Pass to Pass measurements.
Lists essential components and system power requirements for the 600S.
Instructions for mounting the GPS receiver and connecting cables for the 600S.
Instructions for configuring the 600S system using the Viper 4 software.
Details on configuring the 600S for different GPS correction types like GL1DE, SBAS, and GS.
Verifying Port A baud rate and understanding Port B functionality for NMEA output.
How to check receiver hardware, software, GPS position, and correction data quality.
Explanation of LED colors and states for troubleshooting signal and power issues.
A comprehensive list of replacement parts and their corresponding part numbers.
To Next Page
General