12
4. If is displayed in the upper right corner, touch the icon to toggle the
AutoBoom system on.
5. Touch the Left or Right Boom Disabled button to toggle automated boom height
control for each boom.
Important: Booms may raise and lower unexpectedly. Make sure the area
around the booms is clear of obstructions and people before touching these
buttons.
6. Touch if system adjustments are necessary, or to fine tune the AutoBoom
system.
7. Touch the icon to open the job and begin guidance.
Operation
During a job, the AutoBoom Status Indicator will be displayed on the Guidance
screen.
This area may display the following indicators for the current status of the
AutoBoom system:
Status of the center rack is only displayed if a Glide Series AutoBoom system
capable of controlling the center section is connected to the field computer. Touch
the displayed status icon to access the Glide Series AutoBoom Calibration
screen.
Disabled Off Left/Right
Enabled
Both
Enabled
or
Center Rack
Enabled
To Next Page
Loading...
