What to do if Raven TM-1 Control Unit shows no GPS/GGA?
If your Raven Control Unit is not displaying GPS/GGA information, verify that the GPS receiver is outputting GGA messages and that the serial connector is properly installed on the GPS input. Also, check that the GPS receiver baud rate is set between 9600 and 57600 baud.
What to do if Raven TM-1 Control Unit shows over-range?
If your Raven Control Unit is showing an over-range error, try cycling the power to the unit. If the problem persists, perform a Zero Sensor Out procedure.
What to do if Raven TM-1 Control Unit shows no GPS/VTG?
If your Raven Control Unit is not displaying GPS/VTG information, ensure that the GPS receiver is outputting VTG messages and that the serial connector is properly installed. Also, verify that the GPS receiver baud rate is between 9600 and 57600 baud.
Why is my Raven TM-1 running at low speed?
If your Raven Control Unit is running at a low speed, make sure that the vehicle speed is above approximately 2 mph and that VTG messages are enabled.
What to do if Raven TM-1 shows bypass?
If your Raven Control Unit indicates a bypass, try cycling the power to the unit.
What to do if Raven TM-1 shows EEPROM error?
If your Raven Control Unit displays an EEPROM error, try cycling the power several times.
Explains how DGPS position accuracy is affected by machine tilt and how the TM-1 compensates.
Lists the components included in the TM-1 Tilt Module kit, including part numbers.
Describes the TM-1 unit's connectors, status indicator, and configuration methods.
Provides instructions for mounting the TM-1 and lists requirements for installation location and method.
Details how to power the TM-1 module using Raven DGPS receivers or non-Raven receivers.
Explains how to connect the GPS signal from the receiver to the TM-1 for correction.
Provides an introduction to calibrating and setting up the TM-1 for operation.
Explains the TM-1 status indicator light patterns for diagnosing issues.
Details essential settings such as Antenna Height, GPS Delay, Operator Zero, and Baud Rates.
Step-by-step guides for configuring the TM-1 using Cruizer, Envizio, and Viper consoles.
Instructions for setting up and calibrating the TM-1 using a computer and RFP Sim program.
Lists error codes and messages for diagnosing and resolving TM-1 operational issues.
Provides information to help diagnose suspected problems with the TM-1 Tilt Module.
Instructions on how to bypass the TM-1 to test if it is causing operational issues.
Guidance on interpreting LED status patterns and corrective actions for common issues.
General| Category | Control Unit |
|---|---|
| Model | TM-1 |
| Manufacturer | Raven Industries |
| Enclosure Rating | IP67 |
| Input Voltage | 12 VDC |
| Number of Valves Supported | 1 |
| Communication Protocol | CAN |
To Next Page
