Need help?Do you have a question about the Raven ENVIZIO PLUS and is the answer not in the manual?
General| Touchscreen | Yes |
|---|---|
| GPS Navigation | Yes |
| Bluetooth | Yes |
| Wi-Fi | Yes |
| Operating System | Android |
| GPS | Yes |
| Voice Control | Yes |
| Lane Guidance | Yes |
| Speed Limit Alerts | Yes |
| Power Source | Car Charger |
Step-by-step guide to powering on the system and its initial configuration.
Displays GPS signal status and auto-detect options for connectivity.
Initiates a new guidance job session on the system.
Safely powers off the Envizio Plus system.
Navigates to the system's various configuration settings menus.
Icons for menu, patterns (A-B, Last Pass, Pivot), and zoom controls.
Icons indicating SmarTrax engagement and Autoboom operational states.
Steps to begin a new guidance session from the home screen.
Options to choose between Straight, Pivot, and Last Pass guidance.
Marks Point A and Point B to establish the guidance line.
Configures the system for guidance based on the last pass.
Configures the system for circular or pivot guidance.
Automatic spray and boom height control functionalities.
Adjusts swath width and antenna position.
Configures boom number, width, and location.
Sets up lightbar display and external lightbar.
Manages AccuBoom, Autoboom, and boom sense.
Updates system software via USB storage.
Adjusts the width of the application swath.
Configures the antenna's position relative to the vehicle.
Configures the total number of booms used for application.
Activates and configures an external lightbar unit.
Sets up and calibrates the TM1 Tilt Sensor for compensation.
Accesses AccuBoom configuration options for spray control.
Accesses Autoboom configuration options for boom height.
Adjusts turn off percent and look ahead seconds for AccuBoom.
Connects USB device containing software update.
Starts the software installation process.
Provides the recommended method for system shutdown.
To Next Page
