1
Congratulations on your purchase of the Envizio Plus guidance system!
This system is the ultimate guidance solution, featuring numerous guidance
patterns, LED combined with on-screen guidance, datalogging, and much
more.
Initial Start-up
Upon initial start-up of your Envizio Plus system, you will be prompted to
set two configuration settings. Once these two settings are made, the
Envizio Plus is ready for use. You will not be prompted again for these two
settings, only the very first time you power-on the system. After that, if you
wish to change these settings, you may do so via the Configuration Pages,
which you will learn about later in this manual.
Starting the Envizio Plus System
1. Press the Power switch to power-on the Envizio Plus system.
2. The first initial start-up screen, Swath Width, displays. Touch either the
‘10’ or the ‘1’ and then the right or the left red arrow to either
increase or decrease the swath width by increments of 10 or 1. After you
have set the desired number, touch ‘Next’.
To Next Page
Loading...
Need help?
General
