15
7. When you get to the end of your pass and turn the vehicle, Envizio Plus
will detect the nearest area that you mapped and use this as your guid-
ance on the next swath line.
Setting the Pivot Pattern
1. From the Home screen, touch ‘Start Guidance’. Then select ‘Pivot’ as
your pattern.
2. Touch ‘OK’ to proceed with the system generated file name, or touch
‘Change Name’ to type in a name for the file.
3. If you are using a CAN system, the Start Job Options screen displays.
Select if you will be using AccuBoom (and if using a spray zone map)
or AutoBoom for the job, then press OK to start the job.
To Next Page
Loading...
Need help?
General
