30
3. After the message goes away, set your antenna height (in inches) by
touching the red up or down arrows and either the 1 or 10 for
increments. Once you have the antenna height set and you are on level
ground, touch the ‘Calibrate to Level Ground’ button.
4. The Current Tilt Reading and the Calibrated Tilt Reading may now
indicate different numbers (unless your tilt was originally zero).
5. Touch OK. Touch OK again to exit the External Lightbar setup. Now
touch OK again to exit Lightbar Setup. ‘Configuration Page 1’ displays.
Touch Done to return to the Home screen.
To Next Page
Loading...
