13
AutoBoom™
The following sections offer an overview of setting up and using an optional Glide
Series AutoBoom™ system with the Envizio Pro. Refer to the AutoBoom
Calibration & Operation manual for detailed setup and calibration information
regarding the AutoBoom™ system.
To view the Glide Series AutoBoom settings and to enable automatic boom height
control, touch , then and to access the Glide Series AutoBoom
setup screens.
Enabling AutoBoom While Staring a Job
1. Touch the icon on the home screen and touch the AutoBoom button on the
Start Job - Verify Settings screen.
2. Select the Enable AutoBoom option and touch the icon.
3. Complete the procedure in the Start a Job section earlier in this guide and
select the to begin guidance.
4. Before guidance will begin, the operator will be prompted to review the Glide
Series AutoBoom system settings.
The Envizio Pro will display the configuration screen for your Glide Series
AutoBoom™ system. This configuration screen will look similar to the following:
5. If is displayed in the upper right corner, touch the icon to toggle the
AutoBoom system on.
6. Touch the Left or Right Boom Disabled button to toggle automated boom
height control for each boom.
Warning: Booms may raise and lower unexpectedly. Make sure the area
around the booms is clear of obstructions and people before touching these
buttons.
7. Touch if system adjustments are necessary, or to fine tune the
AutoBoom™ system.
8. Touch the icon to open the job and begin guidance.
To Next Page
Loading...
Need help?
General
