Manual # 016-0130-061 Rev A 10/06
9
C HAPTER
T
ROUBLESHOOTING
Question/
Answer
1. How do I keep my wheel from pivoting on the ground when I turn
around?
Answer: On ground that has been worked, it is recommended that the
operator lift the inside boom, when making turns on the ends of the
field. Nothing is being hurt if this isn’t done, but the wheel may dig
when pivoting.
2. My boom is too heavy. How do I adjust this?
Answer: Refer to the Calibration chapter in this manual. Turning the
cartridge adjustment knob on the valve will set how much weight is on
the wheel. Clockwise will make them lighter and counterclockwise will
make them heavier. Note the locking ring must be loosened before
making any adjustments and tightened when complete.
3. Why do I not see the enable indication come on when I press the boom
down switch on my sprayer joystick?
Answer: Some sprayers are not equipped with “Down Coils”. In these
cases, depress the enable function on the controller for the left and right
booms to enable the system.
4. How heavy should my booms be?
Answer: During the calibration process, a test should be done to verify
that the booms are no heavier than 100 lbs. A simple way of checking
this is to enable the Autoboom system and lift each boom tip to ensure
the lift weight is in the proper range. If too heavy, see question 2 on this
page.
5. How do I disable Autoboom?
Answer: Either activate the left and right boom up switches on the
sprayer joystick to disable the PowerGlide Autoboom system or press
the left and right disable function keys on the controller.
To Next Page
Loading...
Need help?
General
