Raven RCM User Manual

CHAPTER 4
22 RCM Dry Manure/Litter Setup Guide
FIGURE 2. Dynamic Cal Setup
DENSITY ADJUSTMENT FREQUENCY
The Adjustment Frequency value is used to determine how often the controller recalculates the Density Factor.
Enter the weight in pounds [kilograms] dispensed before the controller makes an adjustment. The recommended
starting point is 1/20th of the total load weight. This will result in 20 density adjustments per load. On very uneven
loads, the Adjustment Frequency weight value can be decreased, however, rate fluctuation may be observed. If
excessive rate fluctuation is occurring, increase the value.
ADJUSTMENT SENSITIVITY
The Adjustment Sensitivity percentage is used to set how aggressively the controller will adjust the Density Factor.
It is recommended to leave this setting at the default setting of 50% unless otherwise instructed.
If the total applied weight displayed on the controller is not matching the actual scale weight applied, the
Sensitivity percentage may be increased (not to exceed 75%). If erratic rates are observed, reduce this value (not to
be set below 25%) but may lead to some variation between controller totals and scale totals.

Raven RCM Specifications

General

Brand	Raven
Model	RCM
Category	Control Unit
Language	English