What to do if the Raven SCS 660 Recording Equipment console display flashes “CAL” whenever the speed is changed?
If the Raven Recording Equipment console displays a flashing “CAL” message whenever the vehicle’s speed is changed, you should check the battery voltage and connections.
What to do if the Raven Recording Equipment console display flashes “CAL” whenever the vehicle’s engine is started?
If the Raven Recording Equipment console displays a flashing “CAL” message whenever the vehicle’s engine is started, you should check the battery voltage and connections.
What to do if the Raven SCS 660 console display flashes “CAL” whenever the Master switch is turned on or off?
If the Raven Recording Equipment console displays a flashing “CAL” message whenever the Master switch is turned on or off, you should check the battery voltage and connections.
How to fix the SPEED display if it shows as '0' on Raven Recording Equipment?
If the SPEED displays as “0” on your Raven Recording Equipment, follow these steps: 1. Check the speed sensor cable connector and the plug on the back of the console for loose pins. 2. Clean the pins and sockets on the speed sensor cable connections. 3. If a speed sensor extension cable is used, refer to the Testing Speed Sensor Extension Cables section on page 44. 4. If no extension cable is used, replace the speed sensor switch assembly.
How to troubleshoot no lights on my Raven SCS 660 Recording Equipment console?
General| Brand | Raven |
|---|---|
| Model | SCS 660 |
| Category | Recording Equipment |
| Language | English |
To Next Page
