What to do if the Raven SCS 660 Recording Equipment console display flashes “CAL” whenever the speed is changed?
If the Raven Recording Equipment console displays a flashing “CAL” message whenever the vehicle’s speed is changed, you should check the battery voltage and connections.
What to do if the Raven Recording Equipment console display flashes “CAL” whenever the vehicle’s engine is started?
If the Raven Recording Equipment console displays a flashing “CAL” message whenever the vehicle’s engine is started, you should check the battery voltage and connections.
What to do if the Raven SCS 660 console display flashes “CAL” whenever the Master switch is turned on or off?
If the Raven Recording Equipment console displays a flashing “CAL” message whenever the Master switch is turned on or off, you should check the battery voltage and connections.
How to fix the SPEED display if it shows as '0' on Raven Recording Equipment?
If the SPEED displays as “0” on your Raven Recording Equipment, follow these steps: 1. Check the speed sensor cable connector and the plug on the back of the console for loose pins. 2. Clean the pins and sockets on the speed sensor cable connections. 3. If a speed sensor extension cable is used, refer to the Testing Speed Sensor Extension Cables section on page 44. 4. If no extension cable is used, replace the speed sensor switch assembly.
How to troubleshoot no lights on my Raven SCS 660 Recording Equipment console?
If the console is on, but there are no lights lit up on the Raven Recording Equipment console, you can: 1. Check the fuse on the back of the console. 2. Check the battery connections. 3. Check the operation of the Power ON/OFF switch. 4. Return the console to the dealer to have the processor board assembly replaced.
Why is the SPEED reading inaccurate or unstable on my Raven Recording Equipment?
If the SPEED is inaccurate or unstable on your Raven Recording Equipment (Wheel drive speed sensor), you can: 1. Check the speed sensor: a. Run a speed check on a hard surface road. b. If the speed is accurate, move the speed sensor to a different wheel and perform a recheck. 2. Check the magnets: a. Remove one red magnet and one black magnet on the wheel. b. Reposition the remaining red and black magnets directly across from each other. c. Enter a SPEED CAL number in the console twice as large as the correct SPEED CAL number. d. Run a speed check on a hard surface road. e. Remove the two magnets and replace them with the other magnets previously removed. f. Run a speed check on a hard surface road. * If the speed is accurate with only one set of magnets, replace the bad s...
Safety precautions for working with hydraulic systems.
Safety precautions for electrical connections and systems.
Steps for entering initial system data and calibration values.
Adjusting the speed calibration for Raven radar accuracy.
Adjusting the speed calibration for Phoenix 10 sensors.
Verifying and adjusting the spreader constant for optimal performance.
Routine measures to ensure the longevity of the SCS 660 system.
Procedures to test the integrity of flow meter and encoder cables.
Common problems and solutions related to the console.
Common problems and solutions related to rate control.
General| Brand | Raven |
|---|---|
| Model | SCS 660 |
| Category | Recording Equipment |
| Language | English |
To Next Page
