Chapter 3
12 TM-1 Tilt Module Installation & Reference Manual
8. To verify the new antenna height has been set, repeat step 6.
9. If the new antenna height value is displayed after completing step 8, the procedure is now complete. If the
new antenna height is not displayed, repeat step 7 and step 8.
10. Close the RFP Sim program and disconnect serial cable.
To re-calibrate the TM-1 for level ground using a computer:
1. Park on level ground.
2. Type the $PSLIS,ILT,NULL command into blank box at bottom of RFP Sim program and click SEND. This
will recalibrate the TM-1 sensor for level ground.
To Next Page
Loading...
